Hi everybody.
I observe such a problem in version 1.0.0 Rev 1066,
when editing the pin of the board, moving to the left is one not needed step,
to the right there is a lack of two steps.
Possible bug:
After editing the tunnel ID, pressing [Enter] does not result in the expected closure of the properties dialog. the [Esc] key does not cancel the changes, but behaves like the [Enter] key.
The "Text" component does not have the ability to insert text, only copy or cut.
Thank you for your good work!
I observe such a problem in version 1.0.0 Rev 1066,
when editing the pin of the board, moving to the left is one not needed step,
to the right there is a lack of two steps.
Possible bug:
After editing the tunnel ID, pressing [Enter] does not result in the expected closure of the properties dialog. the [Esc] key does not cancel the changes, but behaves like the [Enter] key.
The "Text" component does not have the ability to insert text, only copy or cut.
Thank you for your good work!
Last edited by arcachofo on Mon Apr 18, 2022 4:19 am; edited 2 times in total (Reason for editing : Mark as solved (green color))