Would you like to react to this message? Create an account in a few clicks or log in to continue.

You are not connected. Please login or register

 » Collaborators » Testers » top of Probe seems to be inaccurate (R1255@WIN10)

top of Probe seems to be inaccurate (R1255@WIN10)

2 posters

Go down  Message [Page 1 of 1]

TimFisch

TimFisch

I just hat difficulties in probing wires which are near together.

in the following image the 4V of the lower wire is also shown on the probe which seems to be located on the upper wire

top of Probe seems to be inaccurate (R1255@WIN10) Zwisch13



Last edited by arcachofo on Thu Jun 23, 2022 12:00 am; edited 1 time in total (Reason for editing : Mark as solved (green color))

https://wiki.mexle.hs-heilbronn.de/

arcachofo

arcachofo

Yes, the area of "detection" is too wide to work with wires too close.
I will try to solve this.

arcachofo

arcachofo

Solved at Rev 1274.

Also increased Z value, so probes are on top of everything else.

Sponsored content



Back to top  Message [Page 1 of 1]

 » Collaborators » Testers » top of Probe seems to be inaccurate (R1255@WIN10)

Permissions in this forum:
You cannot reply to topics in this forum