missing properties when simulation starts before properties changes (0.5.16-RC3)

When inserting a wave generator and directly starting the simulation, the frequency and some other properties are not shown.

In the image:
For the upper WaveGen was inserted before starting the simulation. Its properties were opened after starting the simulation. The lower WaveGen was inserted and its properties were opened after starting the simulation.

Sorry, somehow I managed to miss this topic..

I can't reproduce the issue, maybe i'm not doing the correct way.
If I drop a waveGen in the circuit and open properties, this is what I get:

To me it seems more like a glitch and after recording it not fully related to stopping the start.

I'm not folly aware, what's different..

Here a capture of a situation (sorry for the bad YT-upload):

Definetly I was not doing the same.
Anyway I can't reproduce the issue even doing the exact same steps.

I will try to find a posible cause...