Average Time of Meters

SimulIDE_1.0.1-R1374_Win32

I noticed that the actual Voltage and Current Meters have a fixed average time which is relatively short.

So, I wonder if it is possible to add a setting that, in case the measured signal is a direct one but not constant, defines it. For example, for an analog circuit driven by a 50Hz signal, the average time could be set as 20ms or one of its multiples.

Better if there are also two exclusive options to show the maximum or the minimum (instead of the average) during the defined average time.

Added:
Ideally, in case there is a trigger periodic signal, this time setting could be made automatic/dynamic and equal to the time between two consecutive triggering instants (or a multiple of it, as set by the user).

Voltage and Current Meters measure the instant voltage at the same rate than "Canvas Refresh" in Circuit Settings.
It does not work for AC.

arcachofo wrote:Voltage and Current Meters measure the instant voltage at the same rate than "Canvas Refresh" in Circuit Settings.
It does not work for AC.

Ok, so measuring/displaying the average, maximum or minimum voltage cannot be done yet for a DC voltage with ripple (which is periodic usually).

Ok, so measuring/displaying the average, maximum or minimum voltage cannot be done yet for a DC voltage with ripple (which is periodic usually).

No, these are very simple meters.