Latest imagesIs the following circuit too complicated for running in real time?
Too complicated for real time?
2 posters
Message [Page 1 of 1]
2
Re: Too complicated for real time? Mon Sep 26, 2022 12:24 pm
arcachofo
Simulation speed depends on several factors, including your computer speed.
To improve simulation speed you can simplify the circuit:
- Don't use batteries and power lines, instead set the voltages in OpAmps.
- Use only one ground and connect all ground lines to it.
To improve simulation speed you can simplify the circuit:
- Don't use batteries and power lines, instead set the voltages in OpAmps.
- Use only one ground and connect all ground lines to it.
spark likes this post
3 Re: Too complicated for real time? Mon Sep 26, 2022 3:05 pm
spark
Still the same problem:
The circuit begins resonating with low frequencies (as I want it to do) but after a while it jumps to very high frequencies (300 kHz and above) and then real time processing also fails.
The circuit begins resonating with low frequencies (as I want it to do) but after a while it jumps to very high frequencies (300 kHz and above) and then real time processing also fails.
Message [Page 1 of 1]
Similar topics
Permissions in this forum:
You cannot reply to topics in this forum
|
|
|
