Additional modules: shield or microcontroller?

now the pins:

a) on the left edge of package, pressing the shift key adds 4 pin.
b) clicking on each pin, in edit change the name of each of them just like the tunnels in PinID, in name write the same.

Now the 5 pins:
a) On the left edge of package, pressing shift put 4 pins.
b) Clicking on each pin, in edit change the name of each of them the same as the tunnels in PinID, in name write the same.
c) Move the pin towards the image pin.
d) Edit the pin to PointPin

It's time to test it.

send me image

perfect!

c) Move the pin towards the image pin.

send me image

PERFECT!
now connect the led bar to Arduino UNO.

image

I did the test here, but I couldn't connect the image to the Arduino, but to the bar.

Very good, delete the diagram on the right, it was a rehearsal.
Now connect the Arduino UNO pins to your LED bar and load a program that moves the LEDs.

Yes, that's fine too. Since I see that you know how to do it, I attach my work to you.

Damn, amazing! Thank you very much! I took the most ''complicated'' path; It was much easier that way, lol!!!!!!

Maiza, can you attach in a zip your files here?

Now, how would I add this module to the components on the left side?

Please send me your files in a zip, in order to see your work, is it possible?

You know how to do it?

Then I will explain to you how to include the LED bar in the simulide menu in order to use it as another component.

I will send the file.

The directory where the component parts are located must have the following:

a) the sim1 file with the component schematic.
b) the package file with its structure.
Both with the same name.

What you have sent me does not comply with this so we are going to use the MAIZA file that I have sent you within data folder.

1) You copy the folder MAIZA to simulide/data/Tools.
2) In the Tools.xml file include in the last line:



3) copy the MAIZA.png file to simulide/data/images

Now in the simulide components menu, MAIZA will appear in "Tools" ready to use.

Good luck

I'll do it here, now calmly and get back to you.

When you use this component do not forget connect the GND and if the led lights a lot edit the MAIZA.sim1 and change the resistors value from 90 to 100 ohms