Trigger "Single" mode on scope

Hi,

it would be very handy, if scope could be switched to a single trigger mode, so that it would pause after next trigger and resume only after being put to a "single mode" again.

Regards,
Marjan

Logic Analizer has a "kind of" single trigger.
But you can set any condition you want and it pauses the whole simulation.

Have a look here:
https://simulide.forumotion.com/t210-logic-analizer-simulide-0-5-16

That would be extremely useful with analogue signals, too.

The scope could then be paused by combination of a "trigger and channel condition"; something like like "CH1 > 3V and CH2 > 1V" for the latter...

Marjan

Yes, this will be added in a future.

Great!