R1909_CONTROLLER PROPERTIES "CAPADAS" ON SUBCIRCUITS

In 1909 I cannot access these very useful properties in the controller subcircuits. In older versions like R1709 it is possible. Please fix it ASAP. Thanks in advance.



Tell me please...

Ok, I will have a look.

Please, it is important in the AVRs.

Where can I download build 1909???

1909 is SimulIDE 1.1.0, available in the download section.
Direct links to downloads here.

arcachofo wrote:1909 is SimulIDE 1.1.0, available in the download section.
Direct links to downloads here.

Thanks a lot ! I'll test this build!

In 1909 I cannot access these very useful properties in the controller subcircuits. In older versions like R1709 it is possible. Please fix it ASAP. Thanks in advance.

Solved at Rev 1932.

Thank you very much for such a prompt repair, I put it in orange waiting to test it when this version is available, thanks

This IS NOT RESOLVED in the new R1983 version. It is in the same situation as in the R1909 version.

Comment me, please.

It is working for me:

This works and always works in a primitive, but it does not work under a subcircuit.

This works and always works in a primitive, but it does not work under a subcircuit.

I see...
But that is another issue, the issue reported here was this:

Sorry, I may not have explained it well. I will review my posts before sending them to avoid confusion; However, I think that what I am asking for is clear here and also your answer as resolved.

This works and always works in a primitive, but it does not work under a subcircuit.

If what you mean is that properties does not apear in context menu , it is solved at Rev 1984:

The idea is to have access to the entire configuration of the controller primitive from its corresponding subcircuit without any "capado".


For ONE and NANO they should appear in some way:



For TINY84 they should appear in some way:



For TINY85 they should appear in some way:



For MEGA they should appear in some way:



In the particular case of Tiny84 and 85, the RST pin has other functions that are important to configure in order to use it apart from the reset. This worked very well in the reference version 1709.

R1983 looks very good from everything I've tested, congratulations on your excellent work.

Muchas gracias y mucho animo.

Thanks, it works fine and esay to use, thanks,