Would you like to react to this message? Create an account in a few clicks or log in to continue.

You are not connected. Please login or register

Possibility to disable the WDT after a WDT microcontroller reset. Atmega328p

2 posters

Go down  Message [Page 1 of 1]



I was wondering if it is possible for the WDT to be disabled after a WDT microcontroller reset.

At present, the WDT stays on if it is not explicitly disabled in the first few lines of code.

In the real world, a bootloader would be capable of disabling the WDT before the program starts.

Although relying on the bootloader in this case is not considered best practice, it is still a possibility in the real world, and it would be great if it could also work in SimulIDE.

Thank you very much for providing such a wonderful open-source software.

Best regards.



Unfortunately boot loader section is not supported yet.

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum